User Manual

E-25
Attaching the Hand Strap and Stylus
Use the procedure below to attach the hand strap or stylus to the strap holes.
There are 4 strap holes in the terminal (see pages E-13 to E-15). Attach the hand strap
or stylus in the position that makes it easiest for you to use the terminal.
The illustration shows the stylus. Use the same procedure to attach the hand strap.
Precautions for Use
• If you attach the stylus to the strap hole on the barcode reader side of the terminal,
take care to keep the stylus and its retaining cord out of the shot when using the
camera.
Attaching the Anti-slip Hook
How to attach the Anti-slip Hook
1. First check that the anti-slip hook is oriented so that
the projections are facing towards you, as shown in
the illustration. Then push the hook ends into the strap
holes in the terminal.
Check that the hook is securely attached.
Removing the Anti-slip Hook
1. Use the stylus to press on the anti-slip hook as you
pull it out of the strap holes, as shown in the
illustration.
Precautions for Use
• If you are attaching both the anti-slip hook and the hand strap (or stylus), attach the
hand strap (or stylus) to the strap hole on the barcode reader side of the terminal.
• Do not attach the hand strap or stylus to the anti-slip hook. Depending on how the
terminal is used, the strap or stylus could come loose.