User Manual

E-38
Using a microSD Card
DT-X400 supports micro SD cards.
The microSD card slot is located in the battery pack compartment, so you must remove the
battery pack before installing or removing a microSD card.
Installation
1. Turn the terminal off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement
procedure on page E-20)
3. Push the microSD card into the card slot until
it is fully inserted, as shown in the fi gure.
4. Install the battery pack.
(Steps 2 and 3 in the battery pack replacement
procedure on page E-19)
Precautions for Use
• The front and back of the card are diff erent, so the card must be oriented correctly
when inserted into the slot. Inserting the card incorrectly could damage the card
and/or the slot. Take care when inserting cards.
• When turning off the smart handheld terminal, be sure to select “Shutdown” and not
“Hot Swap”.
Removal
1. Turn the terminal off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement
procedure on page E-20)
3. Pull the microSD card out of the card slot, as
shown in the fi gure.
4. Install the battery pack.
(Steps 2 and 3 in the battery pack replacement
procedure on page E-19)