Specifications

Scan Verification Beam

If scanning takes place with the laser beam emitted onto multiple bar codes located near each

other, it is difficult to distinguish by the user which bar code was correctly scanned. In such the

condition, if a laser beam can be emitted again on to the same bar code verifying the actual

scanned bar code the user wishes to scan and a notification about it is issued to the user, the

scanning can be succeeded without having any difficulty or confusion. The Laser Scanner Library

can be used to set “Enable” or “Disable” for this Scan Verification Beam function. The default is

“Disable the scan verification beam function”.

The functions of the Laser Scanner Library relevant to the “Scan Verification Beam” are as

follows.

OBRSetFocus

: Sets up the scan verification beam.

OBRGetFocus

: Retrieves the status of the scan verification beam.

Power ON with Trigger Key

If a Trigger key has been set to “Enable turning on the power with Trigger key”, the power can be

turned on (while the power was being turned off) when it is pressed. This function allows the user

to achieve sequential operations with only one action, turn on the power → press Trigger key →

scan a bar code. This feature is a perfect idea when the user wishes to resume scanning after the

power has been turned off. The default is “Disable turning on the power with Trigger key”.

The functions of the System Library relevant to the “Power ON with Trigger Key” are as follows.

SysSetBootup

: Sets up “Enable or Disable” for turning on power.

SysGetBootup

: Retrieves “Enabled” or “Disable” status for turning on power.

Setting Trigger Key

Various keys such as Enter key, Cursor → key, Cursor ← key, Cursor ↑ key, Cursor ↓ key, R

Trigger key, L Trigger key, and Center Trigger key on the front and sides of the terminal can be

set as scanning trigger key. The default is only R/L Trigger keys and Center Trigger key.

The functions of the Laser Scanner Library relevant to the “Setting Trigger Key” are as follows.

OBRSetScanningKey

: Sets up Trigger keys.

OBRGetScanningKey

: Retrieves the status of Trigger keys.