Specifications

190
Read operation and Read operation 2 Tabs
These tabs are to set the following parameters related to scanning bar code symbologies. Choose a
mode you wish to set in each pull-down menu.
Options of read mode in Read operation Tab (see Figure 3.60)
• Selection of the read method, “Continuous read” or “Single read”.
• Selection of beam width for the scan width control function, “Wide”, “Middle” and “Narrow”.
• Selection of the scan verification beam function, “Disable” or “Enable”.
• Selection of the decoded data output destination, “OBR buffer”, “Clipboard”, or “Keyboard”.
• Selection of termination code, “Disable termination code”, “CR”, “LF”, “CR”, “LF”, or
“TAB”.
• Selection of the decoding level, “Normal” or “High”.
• Selection of the read mode, “Normal read” or “Gradation read (= Multi step read)”.
• Selection of the filter function, “With or without filter” or “With soft filter”. Note that other
filter modes in the pull-down menu are not operable with the terminal.
Options of mode in Read operation 2 Tab (see Figure 3.61)
• Selection of the gain, Gain Mode0 to Mode3.
• Selection of the learning decode function, “Learning Decode ON” or “Learning Decode OFF”.
Figure 3.60 Figure 3.61