Specifications

94
File Format
File format of the configuration file is INI format with the specifications described below.
• The maximum size of the configuration file is 60Kbytes.
• A line starting with “;” is regarded as a comment. It is not regarded as a comment if it locates
in the middle of a line.
• The separator for KEY and VALUE is “=“. Space and tab, etc., also are included in KEY and
VALUE. If a space is inserted after “=“ in “SSID=□tunami”, the SSID value is space +
tunami.
• The end of a line is CR or CR/LF.
• The maximum length of a line is 256 bytes.
• Section name, KEY, and VALUE are case sensitive.
WLAN section
All WLAN settings are made here.
Table 3.60
Key Setting Value
WLANPOWER Specify turning on or off the power to the WLAN module.
1: Power on
0: Power off
POWERSAVE Specify the WLAN power save setting.
1: Enable power save.
0: Disable the power save.
WLANCFG Specify “Enable/Disable” on the configuration file itself.
1: Enable the file.
0: Disable the file.
RoamingRSSILevel Specify roaming threshold value in the range of 0 to 154. This threshold value is
used for the terminal to roam between Access-Points. As soon as the difference
of radio wave strength exceeds over the specified threshold value, the terminal
switches to another Access-Point located nearby to continue the communication.
RoamingAvailableTime None (ignored)
RoamingRSSISpan Specify intensity difference in the range of 0 to 154 for radio wave during
roaming. The more high range of the span is specified, the more strong radio
wave is requited to start roaming.
BandConfig None (ignored)