Specifications

227
Check item Remedies
Reference
page
The captured result is incorrect.
Are unnecessary symbols set to be
captured?
Set only necessary symbols to enable for capture. 224
Is the setup of the parameters for the
symbol correct?
Make the correct settings for symbol parameters.
- Check if the setup for capture output is correct. (Check the
check digit output, start/stop character output, and system
number output.)
224
Print the symbols so as to allow sufficient space between
symbols and distance from other characters.
221 Are symbols close together or are
extra characters or figures printed
around the symbol?
Use the specification of the capture range (Decode Centering
Mode).
217
Is the symbol distorted or warped? Print symbols on a flat surface. 222
Does the symbol data contain
elements other than the character
code?
Control characters, extra characters, and special characters may
not be correctly displayed because they do not have
corresponding fonts. In order to display these characters it is
necessary to use a specific application to make the necessary
conversion.
- Control characters (Tab, CR, LF, etc.)
- Fnc1 (GS) of EAN 128
- Special characters (encircled numerals, roman numerals,
etc.)
- Pictogram
--