Hardware manual

19
Charging the operating battery
Use AC Adaptor (DT-9020ADP) while the
battery pack is being installed in the terminal.
Ways to charge the
battery pack
Use the Cradle-type battery charger while the
battery pack is being installed in the terminal.
Charge method
Constant current and constant voltage
Charge voltage 8.4 V±1%
Charge current
Approx. 400 mA
Approx. 8 hours (for DT-9723LI/DT-9723LIC) Note 4
Charge time
Approx. 72 hours (Memory backup) Note 5
During charging : LED ON in red
Charge indication
After charging : LED ON in green
C-MOS Imager
Method 300,000 pixels, monochrome
Emitting window Redirected downward at 45 degree
1D: 0.15 mm
Stacked 2D: 0.169 mm
Resolution
Matrix 2D: 0.339 mm
1D: 0.45 or greater
Stacked 2D: 0.45 or greater
PCS
Matrix 2D: 0.45 or greater
1D: 40 to 410 mm
Stacked 2D: 50 to 250 mm
Depth
Matrix 2D: 60 to 150 mm
Readable width See Chapter 2.1.2 on page 23.
Readable symbology Refer to IT-3000 Series Software Manual.
Notes:
1. When the battery pack is a brand-new charged fully, and the surrounding temperature is in ordinary level.
2. When the memory backup battery is a brand-new, and the surrounding temperature is in ordinary level.
3. When the memory content is retained by the remaining battery capacity after the operating battery low
warning message appears. The battery pack is being installed in the terminal.
4. When the terminal’s power is turned off. The battery pack is a brand-new, and the surrounding temperature is
in ordinary level.
5. Until when the memory backup battery becomes fully charged. The operating battery is being installed in the
terminal, and the surrounding temperature is in ordinary level.
Weight/Dimensions
Table 2.4
Model no. Dimensions Weight
Approx. 80 (w) x 199.5 (d) x 28 (h) mm (Note 1) Approx. 530 g (Note 3)
IT-3000M53E
Approx. 108 (w) x 265 (d) x 68 (h) mm (Note 2) Approx. 635 g (Note 4)
Approx. 80 (w) x 229.5 (d) x 28 (h) mm (Note 1) Approx. 580 g (Note 3)
IT-3000M54E2
Approx. 108 (w) x 295 (d) x 68 (h) mm (Note 2) Approx. 680 g (Note 4)
Approx. 80 (w) x 229.5 (d) x 28 (h) mm (Note 1) Approx. 600 g (Note 3)
IT-3000M55E, M55U
Approx. 145 (w) x 295 (d) x 70 (h) mm (Note 2) Approx. 700 g (Note 4)
Approx. 80 (w) x 199.5 (d) x 28 (h) mm (Note 1) Approx. 550 g (Note 3)
IT-3000M56E, M56U
Approx. 145 (w) x 265 (d) x 70 (h) mm (Note 2) Approx. 655 g (Note 4)
Notes:
1. The paper holder and other extruding parts on the terminal are excluded.
2. The paper holder and other extruding parts on the terminal are included.
3. The paper holder and hand strap are excluded. The lithium-ion battery pack is installed in the terminal.
4. The paper holder and lithium-ion battery pack installed are included. The hand strap is excluded.