User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
8
5.
Connect the projector to the wireless LAN access point.
(1) Click the [Scan Access Point] button.
When scanning is complete, a down arrow button () appears on the right side of the
“External Access Point SSID” box.
(2) Click the button. On the list that appears, click the SSID of the wireless LAN access point
you want to connect the projector with.
This inputs the SSID you clicked.
If you know the character string that represents the SSID of the wireless LAN access point,
you can input it into the “External Access Point SSID” box manually without clicking the
[Scan Access Point] button.
(3) Click the “Security” box. On the list that appears, select the encryption you want to use for the
wireless LAN access point.
(4) In the “Passphrase/WEP Key” box, input the password of the wireless LAN access point.
Note
Perform the operation below when connecting the projector to an existing network that is a
fixed IP environment.
(1) Click the [Save changes] button.
In response to the restart dialog box that appears, click the [Reboot later] button.
(2) In the sidebar click “Network Settings” (the lower one).
(3) Select the “LAN1 IP Settings (Auto if not checked)” check box.
(4) Input the applicable information for the “IP Address”, “Subnet Mask”, and “Default
Gateway” settings.
6.
Click the [Save changes] button.
In response to the restart dialog box that appears, click the [Reboot now] button. Wait until the
projector restarts.
At this time, the wireless LAN connection between the projector and computer is terminated.
Restarting the projector causes the network standby screen to be projected.
7.
Check if the projector is connected to the wireless LAN access point.
Perform the procedure under “To display the projector’s wireless LAN information screen”
(page 9) and then confirm the information below.
– The wireless LAN information screen “Operation Mode” item is “Client Mode”.
See the sections below for information about how to prepare for and perform network
projection from your computer.
– “Preparing for C-Connection” (page 23)
– “Network Projecting a Computer Screen Image (Using C-Connection)” (page 26)