User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
6
The network standby screen is projected when “Network” is selected as the projector’s input source.
The projector’s basic network information is shown for SSID, etc.
If the message “Network System Now Loading...” is projected after you turn on the projector, it
means that the network system is starting up. Wait a few moments for projection of the network
standby screen.
If an image from HDMI input or the No Signal Screen is projected, it means that “HDMI” is selected
as the input source. To switch the input source to “Network” and project the network standby
screen, perform the steps under “To display the network standby screen” below.
To display the network standby screen
1.
Press the [MENU] key to display the Frequent Functions Menu.
2.
Use the [] and [] keys to select “Switch Input”.
Check to make sure that “HDMI 3 Network” is shown to the right of “Switch Input”.
3.
Press the [ENTER] or [] key.
This changes the input source to Network and closes the menu.
If the message “Network System Now Loading...” is projected, it means that the network
system is starting up. Wait a few moments for projection of the network standby screen.
Projector Network Standby Screen
Network standby screen