User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
41
5.
After you are finished, click the [Logout] button in the upper right corner of the
window.
This will return to the top menu.
Note
If the “Allow control from this page only.” check box is left selected, logging out from the
Moderator page or using a web browser operation to close the Moderator page will re-enable
projection operations from each terminal. The next time you log in to the Moderator page, the
check box will be selected on the page.
The user name list of the Moderator page is automatically refreshed as terminals are
connected to and disconnected from the projector. You can also refresh the list manually by
performing a page reload with your web browser.
You can change the login password for the Moderator page by changing the Projector Setup
page item below.
“System Settings” (page 22) 3 “Change Passwords” 3 “Moderator/Projector Remote
Password”
To use the projector’s keys to control projection from multiple
terminals
1.
While the network standby screen (page 6) is displayed or if network projection
is in progress, press the [ESC] key.
This displays the user list screen, which shows thumbnail images and user names for all the
terminals (12 terminals per screen) currently connected to the projector.
Thumbnails are arranged according to the sequence they were connected with the projector
(C-Connection on a computer or MirrorOp Presenter on a smart device), starting from the
upper left corner and proceeding from left to right.
Each thumbnail also indicates the current projection status ( : not projecting, :
projecting) of each terminal.
2.
Use the cursor keys to move the focus to the thumbnail of the terminal whose
projection status you want to change.
3.
Press the [ENTER] key.
Each press of the [ENTER] key will toggle the projection status of the terminal where the focus
is located between (projecting) and (not projecting).
4.
Repeat steps 2 and 3 as required.
Projection can be performed from as many as four terminals at the same time.
GeorgeBenGillTom
AnneBillyGordonEd
LucyAIHenrySally
Focus
Thumbnail
User name