User`s guide

Resizing a Field (Free Design Template)

Use the procedures in this section when you want to change the size of a field.

Important!

Note that the result obtained when you resize a field depends on whether it is

a text field or an image field.

1. Select the field you want to resize so it is enclosed by a gray selection

boundary.

2. Use one of the techniques described below to drag one of the four corner

handles on the boundary to resize the field.

Example: Simple drag operation

• Simple Drag Operation

Simply dragging a corner handle resizes the field, without maintaining

its aspect ratio.

• [Shift] + Drag

This resizes the field while maintaining its aspect ratio. The field is

enlarged or reduced with the corner that is diagonally opposite from the

one you are dragging fixed.

• [Shift] + [Ctrl] + Drag

This also resizes the field while maintaining its aspect ratio. The field is

enlarged and reduced with its center fixed.

Important!

Resizing a text field does not affect the size of the text inside the field.

Aligning and Resizing Fields (Free Design

Template)

A selection of useful commands makes it possible to instantly position fields

on a label and to make multiple fields the same size (See page 56).

Note

You can use the following procedures for both text fields and image fields.

■ What is alignment?

The DISC TITLE PRINTER application lets you align multiple fields vertically

or horizontally in relation to a reference field that you specify.

Example: To center fields vertically

■ To make multiple fields the same size

You can resize multiple fields so they are the same size as a reference field

that you specify.

Example: Resizing fields by height and width

Reference field

Aligned fields

Reference field

Aligned fields