User Manual

Exam Mode  312
(2) Using the Communication application
1. On the application menu, tap
.
2. Tap [Exam] and then [Enter Exam Mode].
3. Perform steps 3 through 5 under “(1) Using the keypad”.
Only the settings below are saved before entering the Exam Mode.
Basic Format: Number Format, Angle, Complex Format, Decimal Calculation, Assistant, Descending Order,
Variable is Real, Q
1
, Q
3
on Data
Geometry Format: Number Format, Length Unit, Measure Angle, Function Angle
Advanced Format: Transform Definition, FFT Scaling Constant, Assume positive real
System setting: Battery Settings, Language, Imaginary Unit, Keyboard, Touch Panel Alignment
Entering the Exam Mode causes the [Cable Type] setting of the Communication application to be fixed as
3pin cable”.
ClassPad Operation in the Exam Mode
The battery level indicator will change to . The battery level indicator will remain green ( ) for about 15
minutes after you enter the Exam Mode. After that, it will change to blue ( ).
Use the procedure below to display the elapsed time in the Exam Mode.
1. On the application menu, tap
.
2. Tap [Exam] and then [Elapsed Time].
You can restart the elapsed time count by performing one of the operations below.
- Press the RESTART button.
- Remove the calculator’s batteries.
- Re-enter the Exam Mode while already in the Exam Mode.
The table below shows how certain operations affect the Exam Mode.
If you do this:
The ClassPad stays in Exam
Mode.
Data input in Exam Mode is
retained.
Turn power off and then back on
again
Yes Yes
Press the RESTART button Yes No
Remove the ClassPad’s batteries Yes No