User Manual
Table Of Contents
- Cover
- Contents
- Overview and Setup
- Operations Common to All Modes
- Playing on the Keyboard
- Controlling Sounds
- Playing a Built-in Song or a Song on a USB Flash Drive
- Using Auto Accompaniment
- Using Music Preset
- Registering and Restoring a Setup (Registration)
- Recording Your Keyboard Play
- Configuring Function Settings
- USB Flash Drive
- Connecting External Devices
- Connecting to a Computer
- Connecting to Audio Equipment
- Linking with a Smart Device (APP Function)
- Sounding a Bluetooth Audio Capable Device (Bluetooth Audio Pairing)
- Connect the Digital Piano with a Bluetooth Low Energy MIDI Device
- Enabling and Disabling the Digital Piano’s Wireless Function
- Adjusting the Notification Tone Volume Level
- Checking the Bluetooth Connection Status
- Reference
- MIDI Implementation Chart
EN-38
You can use the registration function to register the setup of
the Digital Piano (tone, rhythm, and other settings). You can
recall a registered setup as required to perform a particular
song, etc.
• Registration can be used in the Rhythm Mode (page
EN-30).
• The registration function cannot be used while in the Song
Bank Mode (page EN-26), during demo play (page EN-11),
while in the Music Preset Mode (page EN-37), or while
configuring function settings (page EN-45).
■ Setup Storage Locations
Setup registrations are stored in memory locations that are
divided into eight banks. Each bank has four storage areas,
which means you can register up to 32 setups (8 banks ×
4 areas).
• Use the bt BANK button to specify a bank.
• Specify an area using the ck Area 1 to Area 4 buttons.
■ Registration Memory Data
• Rhythm number
• Synchro start
• Accomp (on, off)
• Keyboard volume
• Accompaniment volume
• Chord input mode
• Split point
• Tone numbers (Upper1, Upper2, Lower)
• Layer (on, off)
• Split (on, off)
• Octave shift
• Duet setting (on, off, octave shift, pan)
•Tempo
• Auto Harmonize (on, off, type)
• Arpeggiator setting (on, off, type)
• Arpeggiator hold (on, off)
• Transpose
•Scale
• Touch Response
• Reverb (on, off, type)
• Chorus (on, off, type)
• Pitch bend range
• Pedal effect
■ Saving to an External Device
Setups saved using registration can be saved to a USB flash
drive in bank units. See “USB Flash Drive Operations” (page
EN-51).
1.
Press br RHYTHM.
2.
Configure the tone, rhythm, and other settings
you can to include in the setup.
3.
Press bt BANK to select the bank you want.
Each press of bt BANK cycles through the bank
numbers.
• You also can select a bank using the bo dial within
three seconds after pressing the bt BANK button.
4.
While holding down cl STORE, press the
button of the area (ck Area 1 to Area 4) where
you want to save the registration.
This will save the settings you configured in step 2 into
the applicable setup.
• If there is anything already stored in the setup, it will be
replaced (deleted) by the new setup.
Registering and Restoring a
Setup (Registration)
Area 1
…
Area 4
Bank 1 Setup 1-1
…
Setup 1-4
Bank 2 Setup 2-1
…
Setup 2-4
.
.
.
.
.
.
Bank 8 Setup 8-1
…
Setup 8-4
bt
ck
Saving a Setup to Registration
Memory
Bank number
Bank 4
Store
Stored in Setup 4-1