User Manual

EN-15
Playing on the Keyboard
■ To layer two tones
• Check to make sure that the U2 (Upper2) and
L (Lower) indicators are not shown on the display before
starting this procedure. If either indicator is displayed, press
co LAYER and/or cn SPLIT so they are not displayed.
1. Press bq TONE.
• Confirm that the arrow mark () is to the right of the
U1 (Upper1) indicator.
2. Use the bo dial to select a tone for the Upper1
part.
Example: 32 ELEC.PIANO 1
3. Press co LAYER.
This displays the U2 (Upper2) indicator, with the arrow
mark () to the right.
4. Use the bo dial to select a tone for the Upper2
part.
Example: 226 STRINGS
5. Play something on the keyboard.
Both tones sound at the same time.
• Pressing co LAYER again will turn layer off.
■ To split the keyboard between two different
tones
1. Select the tone for the Upper1 part (page
EN-14).
•Press bq TONE and then use the bo dial to select the
tone you want.
Example: 312 FLUTE 1
2. Press cn SPLIT.
This displays the L (Lower) indicator, with the arrow mark
() to the right.
3. Use the bo dial to select the Lower part tone
you want.
Example: 60 VIBRAPHONE 1
4. Play something on the keyboard.
This will sound the tones assigned to the left and right
side ranges of the keyboard.
• Pressing cn SPLIT again will turn split off.
• If you turn on both layer and split, layering will be applied to
the right side range of the keyboard only.
E.Pia
no1
Displayed
St r in
g
s
Flute
1
Displayed
Vibes
1
VIBRAPHONE 1 FLUTE 1
F3
Split point