User`s guide

1.0 Introduction

The purpose of the ISC-Imager Demo Application is to demonstrate basic barcode scanning and image

capture capabilities of the Socket In-Hand Scan Card-Imager (ISC-I). It also allows the user to configure the

decoder, image capture, and image transfer capabilities of the ISC-I. The Demo Application was not designed

to be a state-of-the-art image capture application and does not utilize the full configurability or feature set of

the engine. The intent of this application is to demonstrate simple image capture capabilities of the product

until support for the ISC-Imager in SocketScan and related SDK is completed.

Socket’s goal is to include more intuitive and complete image capture utilities in future versions of our

standard SocketScan software and the related Software Developer’s Kit (SDK). At that point, this Demo

Application will be eliminated.

The ISC-Imager Demo Application is automatically installed as part of the SocketScan installation process

and can be launched from the Programs page on your Pocket PC.

IMPORTANT

: The ISC-Imager Demo Application cannot be run simultaneously with SocketScan. If you

intend to use SocketScan, be sure to close the ISC-Imager Demo Application with the Tools | Exit option

rather than the close ‘X’ in the upper right corner of the screen.

Disclaimer

Socket Communications reserves the right to make changes to the software features or functionality and the

information contained in this document without prior notice. If the functionality of the ISC-Imager differs

from that described in this User Guide, the user is encouraged to check the Socket Communications web site

for later versions of this guide. The user may also reach Socket Communications technical support by e-mail

at support@socketcom.com.

Socket Communications shall not be liable for technical or editorial errors or omissions contained herein:

nor the incidental or consequential damages resulting from the furnishing, performance or use of this

material.