User`s guide

Symbology Setup

The Symbology Setup dialog box consists of a symbology

drop down list plus four buttons. The four buttons work as

follows:

Default Symbol: Sets options/parameters for the

indicated symbology to internal defaults.

Default All Symbologies: Sets options & parameters for

all symbologies to internal defaults.

Enable All Symbologies: Enables all symbologies but

does not change other symbol options or parameters.

Disable All Symbologies: Disables all symbologies

without affecting other symbol options.

Selecting a symbology in the drop list will display the

options/parameters setup screen for the selected symbology.

Only the configuration items appropriate for the selected

symbology are displayed. See Appendix A for the default

symbology and parameter settings for the ISC-Imager

Decode Options

No Read Timeout: The length of time the Imager will

attempt to scan before giving up. Default is 6,000

milliseconds (ms).

Multiple Symbol Mode Enable: Enables multiple

symbol (“Shotgun”) decoding. Normally the Imager will

stop attempting to decode when a bar code symbol is

decoded. In Multiple Symbol mode the Imager will not

stop until the trigger is released or the no decode timeout

occurs. Also, the Imager will not read the same barcode

again unless the trigger is released and re-started. This

mode allows the user to scan several bar codes in

succession without re-triggering after each decode (i.e.: a

list of serial numbers).

Use Aimers During Decoding: Turns aimer LED’s on

or off during the decode process when Image capture

Mode is set to Barcode Image.

Center Decode Enable: The user can adjust the size of the scanning area by defining the height and

width (in pixels) of a Center Window. The target bar code must be inside the Center Window before the

Imager will decode it. This feature is important if the user needs to scan a specific bar code in an area

filled with many bar codes, such as a data entry template.