Hardware manual
Table Of Contents
- Safety Precautions
- Operating Precautions
- Contents
- Getting Ready
- Operations
- General Guide
- Using the Stylus
- Recalibrating the Touch Screen
- Adjusting Display Brightness
- Adjusting Auto Dimming Settings
- Changing Applications Assigned to the Program Button
- Using the Cradle
- Using the CASSIOPEIA USB Cable
- Using the AC Adapter
- Infrared Communication
- Using a CompactFlash Card
- Using an SD Memory Card or Multimedia Card
- Built-in Storage
- Using a PC Card Unit (Option)
- Using the PC Card Unit as an External Power Supply
- About the 20Pin/USB host Converter (Option)
- About the Modem Adapter and Modem Card (U.S. and Canada Only)
- Software Applications
- User Maintenance
- Troubleshooting
- Appendix
37
Errors Following a Full Reset
Either of the following two conditions can cause errors to continue, even after you
perform a full reset.
• Hardware defect
• System problem caused by failure by you to correctly perform the reset procedure
before using the unit for the first time
If you suspect that the problem is being caused because you did not properly reset the
unit before using it for the first time, perform the procedure on page 41 of this manual.
This should correct the problem.