Hardware manual
Table Of Contents
- Safety Precautions
- Operating Precautions
- Contents
- Getting Ready
- Operations
- General Guide
- Using the Stylus
- Recalibrating the Touch Screen
- Adjusting Display Brightness
- Adjusting Auto Dimming Settings
- Changing Applications Assigned to the Program Button
- Using the Cradle
- Using the CASSIOPEIA USB Cable
- Using the AC Adapter
- Infrared Communication
- Using a CompactFlash Card
- Using an SD Memory Card or Multimedia Card
- Built-in Storage
- Using a PC Card Unit (Option)
- Using the PC Card Unit as an External Power Supply
- About the 20Pin/USB host Converter (Option)
- About the Modem Adapter and Modem Card (U.S. and Canada Only)
- Software Applications
- User Maintenance
- Troubleshooting
- Appendix
19
To place the CASSIOPEIA onto the cradle
Important
Make sure that CASSIOPEIA power is turned off before you place it onto or remove it
from the cradle.
Use the following procedure to place the unit onto the cradle.
1. Place the cradle on a desk or other flat, level surface.
2. Turn off the CASSIOPEIA.
3. Orient the CASSIOPEIA in relation to the cradle as shown in the illustration below.
Make sure the raised part of the cradle enters into the recess on the back of the
CASSIOPEIA.
1
2
4. Taking care to align the serial connector on the bottom of the CASSIOPEIA with the
connector on the cradle, lower the CASSIOPEIA into the cradle as shown in the
illustration below.
Important
Make sure the CASSIOPEIA lowers securely into the cradle as far as it can go.