User's Manual
Table Of Contents
- Accessories
- Read this first!
- Contents
- General Guide
- Monitor Screen Contents
- Quick Start Basics
- What you can do with your CASIO camera
- Changing the Camera Style to Suit Shooting Conditions
- Using the Touch Panel
- First, charge the battery prior to use.
- Configuring Basic Settings the First Time You Turn On the Camera
- Preparing a Memory Card
- Turning Power On and Off
- To Shoot a Snapshot
- Viewing Snapshots
- Deleting Snapshots and Movies
- Snapshot Shooting Precautions
- Recording Images
- Using BEST SHOT
- Shooting Clearer Snapshots (Multi SR Zoom)
- Digitally Correcting for Overexposure and Underexposure (HDR)
- Shooting with High Speed Night Scene (High Speed Night Scene)
- Shooting with High Speed Anti Shake (High Speed Anti Shake)
- Shooting with Priority on Subject Faces (High Speed Best Selection)
- Shooting a Panorama Image (Slide Panorama)
- Advanced Recording Settings
- Using the REC Menu
- Using Touch Shutter (Touch Shutter)
- Using the Self-timer (Self-timer)
- Using the LED Light (LED)
- Changing the Image Size (Image Size)
- Movie Image Quality Settings (Movie Quality)
- Correcting Image Brightness (EV Shift)
- Adjusting White Balance (White Balance)
- Specifying ISO Sensitivity (ISO)
- Selecting a Focus Mode (Focus)
- Turning on Image Review (Review)
- Using the REC Menu
- Viewing Snapshots and Movies
- Other Playback Functions (PLAY)
- Printing
- Using the Camera with a Computer
- Other Settings (Set Up)
- Adjusting Monitor Screen Brightness (Screen)
- Turning off Eye-Fi Card Communication (Eye-Fi)
- Configuring Camera Sound Settings (Sounds)
- Time Stamping Snapshots (Timestamp)
- Configuring World Time Settings (World Time)
- Setting the Camera’s Clock (Adjust)
- Specifying the Date Style (Date Style)
- Specifying the Display Language (Language)
- Calibrating the Touch Panel (Calibrate TP)
- Selecting the HDMI Terminal Output Method (HDMI)
- Formatting Built-in Memory or a Memory Card (Format)
- Resetting the Camera to Factory Defaults (Reset)
- Configuring Monitor Screen Settings
- Appendix
19
Quick Start Basics
5. Connect the USB
cable to the camera.
The back lamp should
light red, indicating that
charging has started.
The back lamp will go out
when charging is
complete.
• It takes about
130 minutes to bring a
fully dead battery to a
full charge.
• A battery that has not
been used for a long
time or ambient
temperature extremes
can cause charging to
take longer than
normal. If charging takes longer than about six hours, a timer will terminate it
automatically, even if the battery is not fully charged. This is indicated by the
back lamp flashing red. If the battery has not been used for a very long time,
charging may be terminated automatically and the back lamp may start
flashing red after only about 45 minutes. In either case, disconnect the USB
cable from the camera and then reconnect it to resume charging.
Back Lamp Operation
6. After charging is complete, disconnect the USB cable from the camera
and then unplug the power cord from the power outlet.
Lamp Status Description
Lit Red Charging
Flashing Red
Abnormal ambient temperature, USB-AC
adaptor problem, or battery problem
(page 109), or charging terminated by the
timer
Off Charging complete
USB cable
(included with camera)
Making sure that the 8 mark on the USB cable
connector is towards the side opposite that of the
monitor screen, connect the cable to the camera.
[USB] port
Small connector
USB-AC adaptor
Back lamp