Operation Manual

Introduction

Opening/closing the external connector terminal cap, microSD

card slot cap or HDMI micro plug (Type D) cap

<Example: External connector terminal cap>

■ Opening

Hook your finger on the slot and open the cap in the direction of arrow.

Slot

■ Closing

Close the cap by pressing securely in the direction of arrow.

Attaching/removing the EXILIM Phone panel

■ Removing

Holding the FOMA terminal, hook your finger in the

slot and pull up in direction

①

, without applying

excessive force, until the tabs are released. Remove

the EXILIM Phone panel in direc

tion

②

Slot

Tabs

■ Attaching

Close the cap by pressing securely in the

direction of arrow.

Securely push the areas illustrated by

and make sure that there is no space

between the EXILIM Phone panel and

the FOMA terminal.

・

When removing the EXILIM Phone panel, make sure that you drain water (p.22) and wipe moisture off the FOMA terminal.

・

When attaching the EXILIM Phone panel, make sure that no dust or dirt adheres to the EXILIM Phone panel

(especially to the rubber packing).

・

Water or dust might enter the inside of the FOMA terminal unless you attach the EXILIM Phone panel securely.

・

When attaching the EXILIM Phone panel, make sure that the UIM and the battery pack are attached securely. If the UIM is not

securely inserted, the battery pack sits on the UIM which causes a gap between the FOMA terminal and the EXILIM Phone

panel when attaching the EXILIM Phone panel. The waterproof/dustproof function might deteriorate because of the gap.