Specifications

— 50 —
UUID Code is written and registered in EEPROM (lC3) only by the factory.
Refer to SCHEMATIC DIAGRAMS and EXPLODED VIEW in this manual concerning EEPROM.
This code is a sort of the license No. for the individual BE-300 unit.
MP3 etc. files may be unable to be downloaded from Internet Web Site without UUID Code.
Replacing the main PC Board, UUID Code will change.
8-3. Operation Check
You can perform contrast and brightness check without the diagnostic program.
Pressing the right direction cursor button while holding down Power button, the screen becomes lighter.
Pressing the left direction cursor button while holding down Power button, the screen becomes darker.
Pressing the upward/ downward direction cursor buttons while holding down Power button, the contrast can
be adjusted.
Once Main Menu display for the operation check appears, you can pull out CF card.
Even if turning off the unit, Main Menu display can not be deleted.
Because the diagnostic program is written in SDRAM after inserting into the slot of BE-300.
Therefore, you should restore factory defaults after the operatjon check on the safety side. Otherwise,
any malfunction may occur.
8-3-1. Display Check
1. Tapping 1 DISPLAY in Main Menu, all RED display will appear.
2. Tapping the screen, all GREEN display will appear.
3. Tapping the screen, all BLUE display will appear.
4. Tapping the screen, the white frame will appear.
5. Tapping the screen, all BLACK display will appear.
6. Tapping the screen, all WHITE display will appear.
7. Tapping the screen, Main Menu display will appear again.
8-3-2. Touch Screen Panel Check
1. Tapping 2 TOUCH PANEL, the following display will appear.
2. Tapping 1 Case, the following display will appear.
* Touch Panel **
1 Case
2 Points
3 Cross
3. Tapping 1 Case, the following display will appear.
Case ---- > OK
4. After pressing OK button, tap 2 Points.
Doing so, four cross marks will appear.
Tap the center points of these cross marks.
5. Doing so, the following display will appear.
Touch Panel ------- > OK
6. After pressing OK button, tap 3 Cross.
Doing so, a big black cross mark will appear.
7. Trace the center of cross lines from the left to the right, and then trace downwards using a stylus.
Completing this tracing, the white cross mark will appear.
8. Pressing OK button twice, Main Menu display will appear.