Specifications

— 38 —
Back Up/ Restore using PC via PC Connect software
It is necessary to install PC Connect to PC before this Back Up/ Restore.
You can obtain the following documents (page 38~40) clicking Help in the dialog box for PC Connect.
Backup
All the data in your CASSIOPEIA can be stored in PC by using the backup feature. Even if you lose
the data of the CASSIOPEIA, you can restore it from the backup file. You are recommended to
backup your data periodically just in case.
Run backup
Click Menu Bar > Tools > Backup... You can get the same result by pushing the command button on the
Main screen.
First, specify the location where data should be backed up. Enter any location below the Backup File
Location You can also select location after clicking Browse....
Once the location is selected, you can run backup. There are two types of backups:
Back up without quitting: Backup starts without closing any application that might be running on
the CASSIOPEIA.
Quit all and then back up: If there is any application running on the CASSIOPEIA, PC forces it to
close before backup starts.
You can select any of the two backups. Note that you cannot operate your CASSIOPEIA while backup runs.
Confirmation message will be displayed when backup operation is completed. Click OK. Then your
CASSIOPEIA operates in accord ance with the backup type you selected.
Back up without quitting: Top Menu screen will appear.
Quit all and then back up: The CASSIOPEIA automatically restarts.
If you abort backup, Confirmation message will appear. Click OK, and the CASSIOPEIA follows the same
steps described above.
Note:
- The Backup function backs up all files currently stored in CASSIOPEIA memory.
Partial backup of specific data is not supported.
- You can create multiple backups, but make sure there is enough room on your PC's hard disk before
starting.
A backup reauires approximately 12MB of disk space.
- The Backup operations take considerable time to complete.
Because of this, you should always use the AC adaptor to power the CASSIOPEIA when performing
these operations.
Time required with a USB connection: At least 5 minutes
Time required with a serial connection: At least 40 minutes