User Manual
EN-56
Getting Ready
1.
Unfasten the band
that bundles the pedal
cable to the back of crosspiece
and pull
the pedal cord out from the crosspiece.
2.
Attach side panels
and
to crosspiece
. Secure the side panels using four screws
.
• When installing parts
, slide the brackets
into
the slots in either end of crosspiece
. If the brackets
are not inserted into the ends of the crosspiece
as far as they will go, the screws
will not be able to
enter into the screw holes of the brackets
, which
can strip the threads of the screws.
• Cover the screw heads with the caps
.
3.
Slide back panel
into the grooves
of
the side panels.
• When installing back panel
, make sure that the
widely spaced screw holes along the bottom of the
panel are on the left (when viewed from the front of
the stand), and the narrowly spaced holes are on the
right.
4.
Use the two screws
to secure the top left
and right edges of the back panel
to the
brackets
of side panels
and
.
• At location
, slip the clip
onto to the screw
before installing the screw.
1
Pedal cable