User Manual

EN-18
Playing with Different Tones
5. Select the tone for the right side range.
• Use the clw and q arrow buttons to select “U1”
and then press the cmENTER button.
6. Select a tone and then press the cmENTER
button.
• If you want to use layering for the right keyboard
(page EN-16), repeat steps 5 and 6 to select the “U2”
(Upper 2) tone.
7. Press a keyboard key.
• This will sound the tones assigned to the left and
right side ranges of the keyboard.
8. To cancel the split keyboard and switch to a
single tone (Upper 1), press the cnLAYER
button or ckEXIT button.
• Each press of the cnLAYER button toggles between
unlayered (one tone) and layered (two tones).
• Two tone output is enabled while the cnLAYER
button lamp is lit.
1. Hold down the cnLAYER button until the
screen shown below appears.
2. Use the clw and q arrow buttons to
select an item.
3. Use the clu (–) and i (+) arrow buttons to
change the setting.
4. To return to the screen you were at prior to
step 1 of this procedure, press ckEXIT
button.
To modify split settings
Display
Name
Description
Setting
Range
Lower
Octave
Lower Octave. Changes the octave
of the left (Lower) side of a split
keyboard in one-octave units.
A value that is 1 or higher raises
by the specified number of
octaves, while a value that is –1 or
lower lowers by the specified
number of octaves.
–2 to +2
Lower
Volume
Lower Volume. Adjusts the
volume level of the left (Lower)
side of a split keyboard.
0 to 127
Split
Point
Split Point. Specifies the left/right
keyboard split point. The initial
default split point is F#3.
A0 to C8
Lower
Pedal
Lower Pedal. Enables (On) or
disables (Off) damper pedal
operation for the tone of the left
(Lower) side of a split keyboard.
On
(Enabled),
Off
(Disabled)
AP700-ES-1B.indd 20 2015/04/06 12:22:58