User Manual

EN-16
Playing with Different Tones
Use the following procedure to layer two tones, so they
sound at the same time.
1. Press the cnLAYER button.
2. Use the clu and i arrow buttons to
display “LAYER”.
3. Select the main tone.
• Use the clw and q arrow buttons to select “U1”
(Upper 1) and then press the cmENTE R button.
4. Select a tone and then press the cmENTER
button.
• See “Selecting and Playing a Tone” on page EN-10 for
information about how to select a tone.
5. Select the layered tone.
• Use the clw and q arrow buttons to select “U2”
(Upper 2) and then press the cmENTE R button.
6. Select a tone and then press the cmENTER
button.
7. Press a keyboard key.
• Both tones sound at the same time.
8. To cancel layering and switch to a single tone
(Upper 1), press the cnLAYER button or
ckEXIT button.
• Each press of the cnLAYER button toggles between
unlayered (one tone) and layered (two tones).
• Two tone output is enabled while the cnLAYER
button lamp is lit.
• Entering the Duet Mode (page EN-14) or Duet Pan
Mode will disable layering.
• Configuring of layering settings is not supported by
MIDI Recorder Track 2 recording.
1. Hold down the cnLAYER button until the
screen shown below appears.
2. Use the clw and q arrow buttons to
select “Layer Balance”.
3. Use the clu (–) and i (+) arrow buttons to
adjust the layer volume balance.
• –1 or lower: Increases the Upper 1 tone volume.
+1 or higher: Increases the Upper 2 tone volume.
0: Upper 1 and Upper 2 volume the same.
• The setting range is –24 to +24.
4. To return to the screen you were at prior to
step 1 of this procedure, press ckEXIT
button.
Layering Two Tones
X
U 1
X
U 2
To adjust the volume balance between
two layered tones
z L a y e r B a l a n c e
AP700-ES-1B.indd 18 2015/04/06 12:22:57