User manual - Tests (TEST)

The following shows the meaning of each item in the case of list data specification.

Data ............................ data type

1 ................................. sample mean value test conditions (“G

2” specifies two-tail

test, “<

2” specifies one-tail test where sample 1 is smaller

than sample 2, “>

2” specifies one-tail test where sample 1 is

greater than sample 2.)

List(1) .......................... list whose contents you want to use as data of sample 1

List(2) .......................... list whose contents you want to use as data of sample 2

Freq(1) ........................ frequency of sample 1 (positive integer)

Freq(2) ........................ frequency of sample 2 (positive integer)

Pooled ......................... pooling On (in effect) or Off (not in effect)

Save Res .................... list for storage of calculation results (None or List 1 to 20)

Execute ....................... executes a calculation or draws a graph

The following shows the meaning of parameter data specification items that are different

from list data specification.

o1 ................................. mean of sample 1

n-1 ............................ standard deviation (x1

n-1 > 0) of sample 1

n1 ................................. size (positive integer) of sample 2

o2 ................................. mean of sample 2

n-1 ............................ standard deviation (x2

n-1 > 0) of sample 2

n2 ................................. size (positive integer) of sample 2

After setting all the parameters, align the cursor with [Execute] and then press one of the

function keys shown below to perform the calculation or draw the graph.

• 1(CALC) ... Performs the calculation.

• 6(DRAW) ... Draws the graph.

Calculation Result Output Example

2 ........................... direction of test

...................................

t score