User manual - Chapter 4 E-CON

20010101
u To s t art sampling
1. Start the sampling operation by performing one of the function key operations described
below.
• If the final Setup Wizard screen is on the display, press 1(YES).
• If the Advanced Setup menu screen is on the display, press 1(START).
• If the E-CON main menu screen is on the display, press 4(START).
• This sets up the EA-100 using the setup data in the current setup memory area.
•To interrupt a setup while the above screen is on the display, press A.
2. The sampling start dialog box appears after setup of the EA-100 is complete.
• The content of the sampling start dialog box depends on the settings contained in the
setup. See “Operations during a sampling operation” below for information about this
dialog box and other display screens.
u Operations during a sampling operation
Sending a sample start command from the calculator to the EA-100 causes the following
sequence to be performed.
Setup Data Transfer → Sampling Start → Sampling End →
Transfer of Sample Data from the EA-100 to the Calculator
The table on the next page shows how the trigger conditions and sensor type specified in the
setup data affects the above sequence.
4-5-2
Starting a Sampling Operation