User manual

Configuring the Summer Time
Setting (Home City)
The watch’s current time setting can be
change to summer time when required.
[STD]: The watch always indicates standard
time.
[DST]: The watch always indicates summer
time.
Important!
●
If the Home City time zone is an area
where time calibration signal reception
is possible, you can select [AT] (Auto)
for the summer time setting. While [AT]
is specified as the summer time
setting, the first time calibration signal
receive operation after the Home City
enters the summer time period will
cause the watch’s time setting to
switch to summer time. The first time
calibration signal receive operation
after the end of the summer time period
is reached will cause the watch’s time
setting to switch to standard time.
For information about areas where
time calibration signals can be
received, go to the section below.
l
City (Time Zone) List
1.
Pull out the crown to the second click.
The second hand will point to the currently
selected time zone.
●
The mode hand will point to the summer
time setting for the currently selected
Home City.
2.
Hold down (A) for about one second.
Each time you hold down (A) for about one
second, the summer time setting will cycle
to the next available option.
30
3.
Push the crown back in to its normal
position.
Checking the Last Time
Adjustment Result
1.
Enter the Calendar Mode.
l
Navigating Between Modes
30
2.
Press (B).
The second hand will indicate the last time
adjustment operation result. The watch
hands will return to indicating the current
time if you do not perform any operation
for nine or ten seconds.
[Y(YES)]: Last time adjustment operation
successful.
[N(NO)]: Last time adjustment operation
failed.
30
Second hand
Note
●
Even if there was a successful time
calibration signal receive operation or
connection with a phone, the second
hand will point to [N(NO)] if you
adjusted the time and/or date setting
manually.
Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where auto time
calibration signal receive or connection with a
phone may cause problems, you can perform
the procedure below to disable such
operations. To re-enable auto time
adjustment, perform the same operation
again.
1.
Enter the Calendar Mode.
l
Navigating Between Modes
30
2.
Press (B).
The second hand will indicate the last
receive result for nine or ten seconds.
30
3.
Within 10 seconds after pressing (B)
above, pull out the crown to the first click.
●
If more than 10 seconds elapse before
you pull out the crown after you press
(B), the second hand will return to
indicating seconds. If this happens,
press (B) again.
4.
Rotate the crown to disable auto time
adjustment.
[Y(YES)]: Auto time adjustment enabled.
[N(NO)]: Auto time adjustment disabled.
30
Crown
5.
Push the crown back in.
Note
●
If the watch is paired with a phone, G-
SHOCK Connected can be used to
disable auto time adjustment.
l
Using G-SHOCK Connected to
Disable Auto Time Adjustment
Operation Guide 5588
9