User manual

Using the Timer
1.
Enter the Timer Mode.
l
Navigating Between Modes
2.
Press (A) to start the countdown.
30
A beeper sounds for 10 seconds when the
end of the countdown is reached.
●
To pause an ongoing countdown, press
(A). To reset a paused countdown to the
start time, press (B).
3.
Press any button to stop the tone.
Alarm
The watch will beep when the alarm time is
reached.
●
The beeper is muted in the cases described
below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l
Power Saving
Configuring Alarm Settings
1.
Enter the Alarm Mode.
l
Navigating Between Modes
2.
Pull out the crown to the first click.
This turns on the alarm.
3.
Rotate the crown to change the alarm time
setting.
30
Crown
Minutes
Hours
Alarm on
4.
Push the crown back in.
●
To stop the alarm
To stop the alarm after it starts to sound when
the alarm time is reached, press any button.
Note
●
A beeper sounds for 10 seconds when
the alarm time is reached.
●
You can also use G-SHOCK
Connected to configure alarm time
settings.
Turning Off the Alarm
If you leave the alarm turned on, it will sound
every day at the preset alarm time.
To stop the alarm from sounding, perform the
steps below to turn it off.
To have the alarm sound again, turn it on.
1.
Enter the Alarm Mode.
l
Navigating Between Modes
2.
Press (B) to move the second hand to
OFF.
●
Each press of (B) toggles between ON
and OFF.
30
Alarm on
Alarm off
Adjusting Hand and
Day Indicator
Alignment
Strong magnetism or impact can cause the
hands and/or the day indicator to go out of
alignment. If this happens, adjust hand and
day indicator alignment.
●
The watch performs alignment of the hour
hand, minute hand, and second hand
automatically.
Adjusting Hand and Day
Indicator Alignment
1.
Pull out the crown to the second click.
2.
Hold down (B) for at least five seconds
until the second hand points to 12 o’clock .
Release the button when the second hand
reaches 12 o’clock.
This starts auto alignment of the hour
hand, minute hand, and second hand.
●
After auto alignment is complete, the
hands should be in the positions shown
below.
30
Second hand
Minute hand Hour hand
Crown
Operation Guide 5588
16