User manual

Measuring Elapsed Time
30
Seconds
Hours
Minutes
Hour (24-hour time)
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
2.
Use the operations below to measure
elapsed time.
A
A
A
A
Stop
Resume
Stop
Start
3.
Press (B) to reset the elapsed time to all
zeros.
Using Flyback Timing
While a stopwatch elapsed time
measurement operation is in progress,
pressing (B) will instantly return the stopwatch
to all zeros and start a new elapsed time
measurement operation. You can repeat this
operation as many times as you like.
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
2.
Use the operations below to measure
elapsed time.
A
B
B
A
Start 3
Start 2
Start 1
Stop
3.
Press (B) to reset the elapsed time to all
zeros.
Starting a Elapsed Time
Measurement Operation
from the Calendar Mode
(Direct Start)
Direct Start lets you start a stopwatch elapsed
time measurement operation from the
Calendar Mode, without switching to the
Stopwatch Mode first.
1.
Press (A) twice in succession.
●
This starts a stopwatch elapsed time
measurement operation.
30
30
Note
●
Before using Direct Start, make sure
that the stopwatch is reset to all zeros.
ー
If the result of the last elapsed time
measurement operation you
performed is stopped on the
stopwatch display, pressing (A)
twice in succession in the Calendar
mode will display that result.
ー
If the last stopwatch elapsed time
measurement operation you
performed is still ongoing, pressing
(A) twice in succession in the
Calendar mode will display that
ongoing operation.
●
Direct Start is disabled when any one
of the conditions below exists.
ー
While the alarm or timer beeper is
sounding
ー
While a time signal receive operation
is in progress
ー
Bluetooth connection
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
30
Setting the Timer Start Time
1.
Enter the Timer Mode.
l
Navigating Between Modes
2.
Pull out the crown to the first click.
3.
Rotate the crown to change the
countdown start time setting.
●
The countdown start time can be set in
1-minute units up to 24 hours.
30
Crown
Seconds
Minutes
Hours
24-hour
4.
Push the crown back in.
Note
●
You can set a countdown start time of
24 hours by aligning the small 24-hour
hand with 24.
●
You can also use G-SHOCK
Connected to configure timer settings.
Operation Guide 5588
15