User manual

Stopwatch
The stopwatch measures elapsed time in
1/1000-second units for the first hour, and in
1/10-second
units after that for up to 24 hours.
Getting ready
Enter the Stopwatch Mode.
l
Navigating Between Modes
Measuring Elapsed Time
1.
Use the operations below to measure
elapsed time.
D
D
D
D
Stop
Resume
Stop
Start
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
Hours, minutes, seconds,
1/10 seconds
After first hour
Minutes, seconds,
1/1000 seconds
First hour
2.
Press (E) to reset the elapsed time to all
zeros.
Measuring a Split Time
1.
Use the operations below to measure
elapsed time.
●
Pressing (E) causes the elapsed time
up to that point (split time) to be
indicated.
D
E
E
D
Stop
Split release
Split
Start
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
Hours, minutes, seconds,
1/10 seconds
After first hour
Minutes, seconds,
1/1000 seconds
First hour
2.
Press (E) to reset the elapsed time to all
zeros.
Timing the First and Second
Place Finishers
1.
Use the operations below to measure
elapsed time.
D
E
D
2nd Finisher*
1st Finisher*
Start
* Displays the time of the first finisher.
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
Hours, minutes, seconds,
1/10 seconds
After first hour
Minutes, seconds,
1/1000 seconds
First hour
2.
Press (E) to display the time of the second
finisher.
3.
Press (E) to reset the elapsed time to all
zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted in the cases described
below.
ー
When battery power is low
Getting Ready
Enter the Timer Mode.
l
Navigating Between Modes
Operation Guide 5536
10