User manual

3.
Press (C).
Confirm that the small hour hand and
small minute hand are stopped at 12
o’clock.
30
Small minute handSmall hour hand
4.
If the small hour hand and small minute
hand are not at 12 o’clock, rotate the
crown to align them correctly.
5.
Press (C).
Confirm that the mode hand is stopped at
12 o’clock, and check if the day is
indicated properly.
30
30
Day (Operation start day)
Mode hand
6.
If the mode hand and or the day indicator
is out of alignment, rotate the crown to
move the mode hand to 12 o’clock and the
day to the center of the indicator window.
●
The movement range of the mode hand
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
●
After the mode hand and day indicator
are in the positions you want, advance
to step 9 of this procedure. If you are
unable to make the adjustments you
want, go to step 7.
7.
Press (C).
Confirm that the day indicator shows 1.
1
1
Day
●
Changing the date setting will cause the
mode hand to rotate repeatedly. In
some cases, the mode dial may
continue to rotate for about 5 minutes.
l
Hand and Day Indicator Movement
8.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
●
The mode hand moves in conjunction
with crown rotation. Move the mode
hand to 12 o’clock.
9.
Push the crown back in.
Note
●
Leaving the crown pulled out for
more than approximately 30 minutes
without performing any operation
will automatically cause the
adjustment operation to become
disabled. If this happens, push the
crown back in to its normal position
and then pull it out again to restart
the procedure from the beginning.
Pushing the crown in to its normal
position part way through the
alignment procedure will cause the
hands to return to their normal
position. Any alignment you
performed up to that point will be
applied.
Moving to Another Time
Zone
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
●
Before Boarding
1.
Configure the World Time (Dual Time)
setting to the current time at your
destination.
30
Destination time
Current time
l
Using MR-G Connected to Configure
Settings
l
Using Watch Operations to Configure
Settings
2.
Disable auto time adjustment.
30
l
Using MR-G Connected to Configure
Settings
l
Using Watch Operations to Configure
Settings
●
After Arriving
1.
Swap the origin time zone time with the
destination time zone time.
30 30
After swappingBefore swapping
Destination time
Destination time
l
Using MR-G Connected to Configure
Settings
l
Using Watch Operations to Configure
Settings
2.
Enable auto time adjustment.
l
Using MR-G Connected to Configure
Settings
l
Using Watch Operations to Configure
Settings
Operation Guide 5526
16