User manual

Using the Timer
1.
Press (B) to start the countdown.
30
A beeper will sound for 10 seconds to let
you know when the end of a countdown is
reached.
●
To
pause an ongoing countdown, press
(B). To reset a paused countdown to the
start time, press (D).
2.
Press any button to stop the tone.
3.
Press (C) twice to return to the
Timekeeping Mode.
Alarms
The watch will beep when the alarm time is
reached.
●
The
beeper is muted in the cases described
below.
ー
When battery power is low
ー
When watch is at Level 2 power saving
l Power Saving
Getting ready
Enter the Alarm Mode.
l
Navigating Between Modes
30
Configuring Alarm Settings
1.
Pull out the crown to the first click.
This turns on the alarm.
2.
Rotate
the crown to change the alarm time
setting.
30
Crown
MinutesHours
Alarm on
3.
Push the crown back in.
4.
Press (C) once to return to the
Timekeeping Mode.
Note
●
A beeper will sound for 10 seconds
to let you know when the alarm time
is reached.
Enabling/Disabling the Alarm
1.
Press (D) to toggle the alarm between on
and off.
30
Alarm off
Alarm on
2.
Press (C) once to return to the
Timekeeping Mode.
Stopping an Alarm
While the alarm is sounding, press any button
to stop it.
Illumination Light
The watch has an LED light that you can turn
on for reading in the dark. When you turn on
the LED light, it gradually becomes brighter.
After
about two seconds, it gradually becomes
dimmer until it turns off.
Getting ready
Enter the Timekeeping Mode or Alarm Mode.
l
Navigating Between Modes
30 30
Timekeeping Mode Alarm Mode
Turning On the Illumination
Light
Pressing (B) turns on the light.
30
●
The
LED light will turn off automatically if the
alarm starts to sound.
●
The LED light is disabled while the hands
are moving at high speed.
Operation Guide 5502
18