Operation Manual

4.
Rotate
the crown away from you to change
the summer time setting.
●
[AUTO]
The watch switches between standard
time and summer time automatically.
l
Summer Time Table
●
[OFF]
The watch always indicates standard
time.
●
[ON]
The watch always indicates summer
time.
5.
Push the crown back in to complete the
setting operation.
Note
●
The
[AUTO] setting works only when
a Time Signal City is selected for
your Home City.
●
Select [OFF] or [ON] when your
Home
City is not a Time Signal City.
●
Note
that summer time (DST) cannot
be selected while “UTC” is selected
as the Home City.
●
If the currently indicated time is
summer time, [DST] will be shown
on the display.
Setting the Time and Date
1.
Pull out the crown.
The second hand will move to the
currently set city.
Crown
2.
Press (D).
●
You can see if a time is a.m. or p.m. by
checking the second hand position.
PMAM
3.
Rotate the crown to change the minute
setting.
●
The
hour hand will move in accordance
with minute hand movement.
4.
Press (B).
This causes [HOUR] to flash on the
display.
5.
Rotate the crown to change the hour
setting.
6.
Press (B).
7.
Rotate the crown to change the year
setting.
8.
Press (B).
9.
Rotate
the crown to change the month and
day setting.
●
If
you want to change the time and date
settings at this point, press (B). Next,
return to the minute setting in step 3 and
perform the above steps again.
10.
On a time signal at the top of a minute,
push the crown back in to complete the
setting operation.
Digital Compass
You can use the Digital Compass Mode to
determine the direction of north, and to check
your bearing to a destination.
Important!
●
Check the information below to find
out how to ensure correct readings.
l
Calibrating Compass Readings
(Bidirectional Calibration)
l
Digital Compass Reading
Precautions
Getting ready
Enter the Compass Mode.
l
Navigating Between Modes
Digital Compass Mode
●
Entering the Compass Mode starts
compass readings.
●
If you point 12 o’clock in the direction of an
objective and then enter the Compass
Mode, the bearing to the objective will
appear immediately.
Taking a Compass Reading
Keeping the watch level, point 12 o’clock in the
direction of your desired objective. The
second hand will indicate north. The bearing
and bearing angle to your objective will also
appear on the display.
●
To retrigger the compass operation, press
(C).
Interpreting Bearing Readings
315°
0°
Bearing
Bearing angle to objective
Bearing to objective
North
Objective
Directions: N (North), E (East), W (West), S
(South)
Operation Guide 5470
8