Operation Manual

Auto Time Signal Receive
An automatic time signal receive operation is
performed and the time and day settings are
adjusted between midnight and 5:00 a.m.
Once
a signal receive operation is successful,
no more auto receive operations are
performed that day.
The receive operation is performed only while
the watch is in the Timekeeping Mode.
l
Navigating Between Modes
Mode hand
Place the watch near a window or some other
location appropriate for signal reception.
●
When the receive operation is successful,
the time and day settings will be adjusted
automatically.
Note
●
Reception takes anywhere from
about two minutes to about 10
minutes. It can take as long as 20
minutes.
●
Using Auto Receive
Before going to bed at night, put the watch into
the Timekeeping Mode (whose settings
should be configured correctly), and leave it
near a window.
Enabling/Disabling Auto Receive
Use the procedure below to enable or disable
Auto Receive.
Getting ready
Enter the Receive Mode.
l
Navigating Between Modes
1.
Pull out the crown.
2.
Rotate the crown to select either [ON] or
[OFF].
[ON]: Auto receive is on.
[OFF]: Auto receive is off.
3.
Push the crown back in to complete the
setting operation.
4.
Press (B) to return to the Timekeeping
Mode.
Manual Time Signal Receive
You can use a button operation to receive the
time
signal. When a receive is successful, the
time and date settings will be adjusted
automatically.
Getting ready
Enter the Receive Mode.
l
Navigating Between Modes
1.
Place the watch near a window or some
other location appropriate for time signal
reception.
2.
Hold down the (A) button for about two
seconds until [RC!] appears on the dot
display.
This indicates that time signal reception
has started.
●
To cancel an ongoing time signal
receive operation, press any button.
After time signal receive ends, the result
of
the receive operation will appear on the
display.
2 seconds
UnsuccessfulSuccessful
3.
Press (B) to return to the Timekeeping
Mode.
●
If
reception fails for some reason, check
the surrounding reception environment
and then try again.
Note
●
Reception takes anywhere from
about two minutes to about 10
minutes. It can take as long as 20
minutes.
●
The watch will automatically return
to the Timekeeping Mode if you do
not perform any operation for about
two
or three minutes after time signal
receive ends.
Operation Guide 5470
6