Operation Manual

Adjusting Hand Alignment
1.
Pull out the crown.
2.
Hold down the (A) button for about five
seconds until [HAND ADJ] flashes on the
display.
This indicates that hand alignment
adjustment has started.
●
[HAND SET] will flash first on the
display about 0.5 seconds after you
hold down the (A) button. Keep the
button depressed until [HAND ADJ]
flashes on the display.
●
All of the hands will move to 12 o’clock
when hand alignment adjustment is
complete.
3.
Check to make sure that all of the hands
are stopped at 12 o’clock.
●
Hand alignment will not be adjusted
correctly
if you advance to the next step
while the hands are still moving.
4.
Push the crown back in to complete the
setting operation.
●
After hand alignment adjustment is
complete, check to make sure that the
proper time is being indicated in the
Timekeeping Mode by the hands and
on the digital display. If the time
indication is not correct, adjust hand
alignment again.
Other Settings
Getting ready
Enter the Timekeeping Mode.
l
Navigating Between Modes
Timekeeping Mode
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the
tone that sounds when you press a button.
1.
Pull out the crown.
The second hand will move to the
currently set city.
Crown
2.
Press (B) twice so the current setting
([KEY♪] or [MUTE]) is displayed.
3.
Rotate the crown to select either [KEY♪]
or [MUTE].
[KEY♪]: Operation tone is enabled.
[MUTE]: Operation tone is muted.
4.
Push the crown back in to complete the
setting operation.
Configuring Power Saving
Function Settings
1.
Pull out the crown.
The second hand will move to the
currently set city.
Crown
2.
Press (B) six times so [P.SAVE] is
displayed.
3.
Rotate the crown to turn the setting on or
off.
[ON]: Power Saving enabled.
[OFF]: Power Saving disabled.
4.
Push the crown back in to complete the
setting operation.
Note
●
For
details about Power Saving, see
“Power Saving Function”.
Operation Guide 5470
22