Operation Manual

Selecting a Timekeeping
Mode Digital Display Format
In the Timekeeping Mode, you can use the
operation
below to change the contents of the
digital displays.
p
D
p
D
D
Day of the week,
month, day
Hour, minute, second
Barometric pressure
graph
Using the Crown
The watch’s crown is a screw-in (screw lock)
type. To use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
Loosen
Crown
●
Pulling Out and Pushing In the Crown
Pull out the crown before performing crown
operations. Do not pull the crown with too
much force.
Normal timekeeping
Pull out
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be
sure
to screw the crown in by rotating
it away from you as you push it in.
Screw in
●
When pushing the crown back in,
take care not to apply too much
force.
●
Fast Forward/Fast Reverse
After pulling out the crown, rotating it quickly
in
succession in either direction will start a fast
forward or fast reverse operation. While a fast
forward operation is in progress, quickly
rotating the crown in succession again will
increase the speed even further.
●
The fast reverse operation speed is fixed
and cannot be changed.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If you do not perform any operation
for about two minutes after pulling
out the crown, crown operations will
automatically become disabled. If
that happens, push the crown back
in and then pull it out again.
●
The message [PUSH] will appear on
the display in the cases below. If that
happens, push the crown back in
and then pull it out again.
ー
When the crown is pulled out while
in a mode that does not support
crown operation
ー
When you do not perform any
operation for about two minutes
after pulling out the crown
Shifting the Hands
Hand shift moves the hands out of the way for
easy viewing of display info.
1.
While holding down (L), press (B).
●
All hands will move to 2 o’clock.
2.
To return the hands to their normal
timekeeping
positions, press (A), (B), (C),
or (D).
Note
●
This function can be used in any
mode.
ー
Hand shift cannot be used while
configuring the city code or the
summer time setting, or when
manually configuring time and
date settings.
●
Shifted hands will return to their
normal positions if no button
operation is performed within about
ten
seconds after hands are shifted.
●
In the modes below, hands that are
blocking a digital display will
automatically move to 4 o’clock or 8
o’clock.
The hands will return to their
normal positions after about three
seconds.
ー
Altimeter Mode
ー
Barometer Mode
ー
Thermometer Mode
Operation Guide 5470
2