Operation Manual

Measuring Elapsed Time
1.
Use the operations below to measure
elapsed time.
A
A
A
A
nnn
Stop
Resume
Stop
Start
Hours, minutes, seconds, 1/100 seconds
2.
Press (C) to reset the elapsed time to all
zeroes.
Measuring a Split Time
1.
Use the operations below to measure
elapsed time.
A
C
C
A
nnn
Stop
Split release
Split
Start
Hours, minutes, seconds, 1/100 seconds
2.
Press (C) to reset the elapsed time to all
zeroes.
Timing the First and Second
Place Finishers
1.
Use the operations below to measure
elapsed time.
A
C
A
C
nnn
Split release
(Time of 2nd finisher)
2nd Finisher
1st Finisher
(Time of 1st finisher)
Start
Hours, minutes, seconds, 1/100 seconds
2.
Press (C) to reset the elapsed time to all
zeroes.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Getting ready
Enter the Timer Mode.
l
Navigating Between Modes
Timer Mode
Setting the Timer Start Time
1.
Pull out the crown.
This will cause the timer minutes digits to
flash.
Minutes
Crown
2.
Rotate the crown to change the minutes
value.
The start time can be set in 1-minute units
up to 60 minutes.
3.
Push the crown back in to complete the
setting operation.
Using the Timer
Press (A) to start the countdown. A beeper
sounds when the end of the countdown is
reached.
●
Pressing (A) toggles the countdown
between pause and resume.
●
Pulling out the crown while a countdown is
in
progress will reset to the countdown start
time. You can then use the crown to change
the start time.
Start/Stop
Reset
Minutes, seconds
●
To
stop the timer and reset it to the start
time
1.
While a countdown operation is in
progress, press (A).
This stops the timer.
2.
Press (C).
This resets the timer to the start time.
Stopping the Timer
Pressing any button while the timer beeper is
sounding stops it.
Operation Guide 5470
18