Operation Manual

Note
●
If
there is no data left in memory due
to a data delete operation, error, or
some other reason, [- - - -] or [0] will
appear on the display.
●
If the cumulative ascent (ASC) or
cumulative descent (DSC) value
exceeds 99,999 m (327,995 feet), it
will revert to 0 and continue from
there.
●
Pressing (D) returns to the top
screen (record number, DSC, ASC,
MAX,
or MIN) of the data that you are
viewing.
●
Manually Recorded Data
After displaying the top screen of a manually
recorded
data record (01 through 30), you can
navigate between the record’s data screens
as shown below.
Example: Manually recorded Record 01
D
D
2 seconds
2 seconds
1 second
Altitude Time
Recording date
Record number
●
Auto Recorded Data
High altitude and low altitude
Example: High altitude
D
D
2 seconds
2 seconds
1 second
Altitude
Time
Recording dateData type
Cumulative ascent and cumulative
descent
Example: Cumulative ascent
D
D
2 seconds
1 second
Cumulative altitude
Date when
accumulation started.Data type
Deleting a Particular Record
1.
Use the (A) and (C) buttons to scroll
through
the top screens of the records and
display the one you want to delete .
●
Note that holding down the (D) button
for more than five seconds in step 2
below will delete all data.
2.
Hold down the (D) button for
approximately two seconds. Release the
button as soon as [CLEAR] changes from
flashing to not flashing.
This deletes the record you selected.
Deleting All Records
Hold down the (D) button for about five
seconds, until the message [CLEAR ALL]
changes from flashing to not flashing. This
deletes all the altitude record data.
Stopwatch
The stopwatch can be used to perform 1/100
second elapsed time measurement up to 23
hours, 59 minutes, 59.99 seconds.
It can also measure split times.
Getting ready
Enter the Stopwatch Mode.
l
Navigating Between Modes
Stopwatch Mode
Note
●
Elapsed time returns to zero
automatically and timing continues
from there when the maximum limit
is reached.
●
Once started, elapsed time
measurement continues until you
press (C) to reset the stopwatch,
even if you change to a different
mode and even if the stopwatch
reaches the elapsed time
measurement limit.
●
Exiting the Stopwatch Mode while a
split time is frozen on the display
clears the split time and returns to
elapsed time measurement.
Operation Guide 5470
17