User manual

Note
●
The connection will be terminated if
you do not perform any operation on
the watch or phone for a fixed
amount of time.
To specify the connection limit time,
perform the following operation with:
use CASIO WATCH+ to select
“Watch settings” n “Connection
time”, and then specify a setting of 3
minutes, 5 minutes, or 10 minutes.
Entering the Watch Airplane Mode
Use the Airplane Mode to disable Bluetooth
radio wave emissions.
Enter the Airplane Mode when in a hospital, in
an aircraft, or anywhere else where radio wave
emissions are restricted.
Important!
●
The functions below are disabled in
the Airplane Mode.
ー
Auto adjust
ー
Phone finder
ー
Bluetooth connection
1.
X Hold down (A) for about four seconds,
until the mode hand moves to the airplane
mark.
The watch will enter the Airplane Mode.
●
Each time (A) is held down for about four
seconds, the watch enters or exits the
Airplane Mode.
30
Airplane mark
Unpairing
To unpair the watch from a phone, delete the
pairing information from CASIO WATCH+, the
phone, and the watch.
●
Deleting Pairing Information from
CASIO WATCH+
1.
X If the watch is connected with a phone,
press (C) to terminate the connection.
30
30
n
After disconnectionConnected
2.
Y On CASIO WATCH+, tap “Connection
settings”.
3.
Y In “Previously registered watch”, tap the
watch you want to unpair.
4.
Y Tap “Delete pairing registration”.
5.
Y Tap “Yes”.
This deletes the watch’s pairing
information from CASIO WATCH+.
●
Deleting Pairing Information from a
Phone
iPhone Users
1.
Y On the Home Screen, tap “Settings” n
“Bluetooth”.
2.
Y Tap g next to “CASIO EQB-510”.
3.
Y Tap “Forget this Device”.
This deletes the watch’s pairing
information from the phone.
Android Users
1.
Y On the App screen tap: “Settings” n
“Bluetooth”.
2.
Y Tap j next to “CASIO EQB-510”.
3.
Y Tap “Unpair”.
This deletes the watch’s pairing
information from the phone.
4.
Y Scroll the status bar downwards and
open the notification panel.
5.
Y Tap e (Bluetooth) to disable Bluetooth,
and then re-enable it.
Note
●
Note that the actual operation you
need to perform depends on the type
of phone you are using. For details,
see your phone documentation.
●
Deleting Pairing Information from the
Watch
1.
X Pull out the crown to the second click.
30
Crown
2.
X Hold down (D) for about 5 seconds.
This causes the second hand to perform
one revolution and deletes the pairing
information.
3.
X Push the crown back in.
If you purchase another phone
You need to perform the operation below
whenever you want to establish a Bluetooth
connection with a phone that is different from
the one you are currently connected with.
1.
Clear the current pairing info.
2.
Pair the watch with the other phone.
Operation Guide 5429
8