User manual

Q3
Button operations become disabled
after I change to another mode.
When you change from one mode to another,
button operations are disabled during the
period that the hands are moving to indicate
information in the entered mode. Wait until the
hands stop moving before performing button
operations.
Q4
The second hand is jumping at two-
second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
l
Charging the Watch
Q5
All hands are stopped at 12 o’clock
and buttons do not work.
The battery is dead. Keep the watch exposed
to light until the battery recharges sufficiently.
l
Charging the Watch
Q6
The hands suddenly start moving at
high speed.
This is due to one of the reasons below, and
does not indicate malfunction. Simply wait
until normal hand movement resumes.
●
The watch is recovering from a Power
Saving condition.
l
Power Saving Function
●
Watch time settings are being adjusted in
accordance with phone settings.
l
Auto Time Adjustment
Q7
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q8
Hands and the day indicator are out
of alignment.
Strong magnetism or impact may cause the
hands of the watch to go out of alignment. Use
CASIO WATCH+ to correct hand alignment.
l
Adjusting Hand Alignment
Q9
The time setting is correct, but the
day indicator is between days.
The day is in the process of changing. For
information about how the day changes, see
the section below.
l
Changing Hand and the Day Indicator
Settings
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately 30 minutes in the case of hand
and day indicator alignment operations),
crown operations will automatically become
disabled. If that happens, push the crown back
in and then pull it out again.
l
Using the Crown
Q2
Crown operation does not work.
Crown operation is disabled while a hand fast
forward operation is in progress. Stop the
hand fast forward operation to perform the
crown operation you want.
Charging
Q1
The watch does not work even
though it is exposed to light.
The watch stops operating whenever the
battery goes dead. Keep the watch exposed
to light until it recharges sufficiently.
l
Charging the Watch
Operation Guide 5429
15