Operation Manual

Entering the Watch Airplane Mode
Use the Airplane Mode to disable Bluetooth
radio wave emissions.
Enter
the Airplane Mode when in a hospital, in
an aircraft, or anywhere else where radio wave
emissions are restricted.
Important!
●
The functions below are disabled in
the Airplane Mode.
ー
Auto adjust
ー
Phone finder
ー
Bluetooth connection
1.
X Hold down (A) for about four seconds,
until
the mode hand moves to the airplane
mark.
The watch will enter the Airplane Mode.
●
Each
time (A) is held down for about four
seconds, the watch enters or exits the
Airplane Mode.
30
Airplane mark
Unpairing
To unpair the watch from a phone, delete the
pairing
information from CASIO WATCH+, the
phone, and the watch.
●
Deleting Pairing Information from
CASIO WATCH+
1.
X If the watch is connected with a phone,
press (C) to terminate the connection.
30
30
n
After disconnectionConnected
2.
Y On the Home Screen, tap the “CASIO
WATCH+”
icon.
3.
Y Tap the CASIO WATCH+ j icon.
4.
Y In the “Previously registered watch” list,
tap the watch you want to unpair.
5.
Y Tap
“Delete pairing registration”.
6.
Y Perform the operation shown on the
phone screen.
●
Deleting Pairing Information from a
Phone
iPhone Users
1.
Y On the Home Screen, tap “Settings” n
“Bluetooth
”.
2.
Y Tap g next to “CASIO EQB-510”.
3.
Y Tap
“Forget this Device”.
4.
Y Tap
“Forget Device”.
This deletes the watch’s pairing
information from the phone.
Android Users
1.
Y On the App screen tap:
“Settings” n
“Bluetooth”.
2.
Y Tap j next to “CASIO EQB-510”.
3.
Y Tap
“Unpair”.
This deletes the watch’s pairing
information from the phone.
4.
Y Scroll the status bar downwards and
open the notification panel.
5.
Y Tap e (Bluetooth) to disable Bluetooth,
and then re-enable it.
Note
●
Note that the actual operation you
need
to perform depends on the type
of phone you are using. For details,
see your phone documentation.
●
Deleting Pairing Information from the
Watch
1.
X Pull out the crown to the second click.
30
Crown
2.
X Hold down (D) for about 5 seconds.
This causes the second hand to perform
one revolution and deletes the pairing
information.
3.
X Push the crown back in.
If you purchase another phone
You need to perform the operation below
whenever you want to establish a Bluetooth
connection with a phone that is different from
the one you are currently connected with.
1.
Unpair the watch from your current (old)
phone.
l
Clear the current pairing info.
2.
Pair the watch with your new phone.
l
Pair the watch with the other phone.
Operation Guide 5429
8