User manual

Display Illumination
The face of the watch can be illuminated for
reading in the dark.
Illuminating the Display
Pressing (B) in any mode turns on illumination.
Note
●
The light may flicker if it is turned on
while there is a Bluetooth
connection.
●
The light will turn off if it is on when
an alert operation starts.
Specifying the Illumination
Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1.
Press (D) to enter to the Timekeeping
Mode.
l
Navigating Between Modes
2.
Hold down the (A) button for about two
seconds.
[SET] will appear first, followed by the
Home Time City name.
3.
Press (D) 3 times until the current setting
([LT1] or [LT3
]) flashes on the display.
4.
Press (E) to toggle between the two
illumination duration settings.
[LT1
]: 1.5-second light
[LT3]: 3-second light
5.
Press (A) twice to exit the setting screen.
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, correct the hand position.
Getting ready
Perform this procedure in the Timekeeping
Mode. Use (D) to navigate to the Timekeeping
Mode.
l
Navigating Between Modes
Timekeeping Mode
Adjusting Hand Alignment
1.
Hold down the (A) button for about five
seconds.
[H.SET] will appear, and then [SUB] will
flash on the display.
Small
minute hand
Small hour hand
2.
If the
small hour and minute hands are not
at 12 o’clock, use (B) and (E) to move them
there.
●
Holding down (B) or (E) moves the
hands at high speed.
3.
Press (D).
This enables correction of hour and
minute hand alignment.
●
Watch operations are disabled while
hands are moving.
Minute hand
Hour hand
4.
If the
hour and minute hands are not at 12
o’clock, use (B) and (E) to move them
there.
5.
Press (D).
This enables adjustment of second hand
alignment.
6.
If the
second hand is not at 12 o’clock, use
(B) and (E) to move it there.
7.
Press (A) to return to the Timekeeping
Mode.
Other Settings
Getting ready
Perform this procedure in the Timekeeping
Mode. Use
(D) to navigate to the Timekeeping
Mode.
l
Navigating Between Modes
Timekeeping Mode
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the button operation tone.
1.
Hold down the (A) button for about two
seconds.
[SET] will appear first, followed by the
Home Time City name.
2.
Press (D) twice until the current setting
([KEY♪]
or [MUTE]) flashes on the display.
Operation Guide 5427
14