User manual

Using the Timer
1. Press (A) to start the countdown.
30
A beeper sounds when the end of the
countdown is reached.
●
To pause an ongoing countdown,
press (A). To reset a paused
countdown to the start time, press
(B).
2. Press any button to stop the tone.
3. Press (C) twice to return to the
Timekeeping Mode.
Alarms
The watch will beep when the alarm time
is reached.
●
The beeper is muted in the cases
described below.
ー
When battery power is low
ー
When watch is at Level 2 power
saving
l Power Saving Function
Getting ready
Enter the Alarm Mode.
l Navigating Between Modes
30
Configuring Alarm Settings
1. Pull out the crown to the first click.
This turns on the alarm.
2. Rotate the crown to change the alarm
time setting.
30
Alarm on
Alarm hour/minute
Crown
3. Push the crown back in.
4. Press (C) once to return to the
Timekeeping Mode.
Enabling/Disabling the
Alarm
Press (B) to toggle the alarm between on
and off.
30
Alarm on
Alarm off
Stopping an Alarm
While the alarm is sounding, press any
button to stop it.
Illumination Light
The watch has an LED light that you can
turn on for reading in the dark. When you
turn on the LED light, it gradually
becomes brighter. After about two
seconds, it gradually becomes dimmer
until it turns off.
Getting ready
Enter the Timekeeping Mode or Alarm
Mode.
l Navigating Between Modes
Turning On the Illumination
Light
Pressing (A) turns on the light.
30
●
The LED light will turn off automatically
if the alarm starts to sound.
●
The LED light is disabled while the
hands are moving at high speed.
Adjusting Time Settings
Manually
You can use the procedure below to
adjust the watch’s time and day settings
when GPS and time calibration signal
reception is not possible for some
reason.
Selecting a Time Zone
Use the procedure in this section to
select a city (time zone) to use as your
Home City. If you are in an area that
observes summer time, you can also
enable or disable summer time.
Operation Guide 5411
9