User manual

Note
●
The initial factory default
summer time setting for all cities
(time zones) is “AT (AUTO)”.
With this setting, the watch
automatically switches between
summer time and standard time
as required. The “AT (AUTO)”
setting lets you use the watch
without worrying about
changing the summer time
setting.
●
When performing a manual
operation to select a time zone
for which there is no city name
displayed, use “STD” or “DST”
for the summer time setting.
●
In the cases described below,
receiving GPS position
information will automatically
cause “AT (AUTO)” to be
selected for the summer time
setting.
ー
When the time zone of the
current receive operation is
different from the watch’s time
zone setting prior to the
receive operation.
ー
When the time zone is
unchanged, but the acquired
position information is for a
geographic area with different
summer time rules (start date,
end date)
1. Pull out the crown to the second click.
The second hand will move to the
currently selected time zone.
30
Crown
Time zone
2. Rotate the crown to change the time
zone.
●
You can also select a time zone
whose name is not indicated on
the face of the watch.
●
For information about time zones,
see the “City (Time Zone) List”.
3. Hold down (A) for about one second
to change the summer time setting.
●
Each press of (A) cycles through
available settings in the sequence
shown below.
“AT (AUTO)” n “STD” n “DST”
3
0
●
“AT (AUTO)”
The watch switches between
standard time and summer time
automatically.
●
“STD”
The watch always indicates
standard time.
●
“DST”
The watch always indicates
summer time.
4. Push the crown back in to its normal
position.
Summer Time
Summer time, which is also known as
Daylight Saving Time (DST), advances
the time setting one hour, 30 minutes, or
some other amount of time from standard
time (STD) during the summer months.
Whether or not and how summer time is
used depends on your country or local
area. Summer time is not used in some
countries and local areas.
Adjusting the Time and Day
Setting
1. Pull out the crown to the second click.
The second hand will move to the
currently selected time zone.
30
Hours
Minutes
Crown
Time zone
2. Hold down (C) for about 10 seconds.
This causes the second hand to
move to 12 o’clock and enables the
hour and minute setting operation.
3. Rotate the crown to adjust the hour
and minute settings.
4. Press (C).
This enables the year 10’s digit
setting operation.
80
90
30
40
20
50
70
10
60
00
＋
−
Year (10’ s digit)
5. Rotate the crown to move the second
hand to the desired setting for the
year ten’s digit.
6. Press (C).
This enables the year one’s digit
setting operation.
8
9
3
4
2
5
7
1
6
0
＋
−
Year (1’ s digit)
7. Rotate the crown to move the second
hand to the desired setting for the
year one’s digit.
Operation Guide 5411
10