User manual

Operation Guide ANA(HK1)V.I
2
To set time
• Some water resistant models are equipped
with a screw lock crown.
• With such models, you must unscrew the
crown in the direction noted in the
illustration to loosen it before you can pull it
out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water
resistant while their crowns are loosened.
Be sure to screw the crowns back in as far
as they will go after making any setting.
Setting time
1) Pull the crown out.
2) Set the hands by turning the crown in either
direction. For watch with the small second
hand might move while you set the time, but in
that case the internal circuit will maintain the 0
setting in memory.
３針（時・分・秒）
Crown
２針（時・分）
Crown
3) Push the crown in to the normal position.
To set the watch by a time signal accurately, first
turn the hands clockwise and put the watch four or
five minutes forward, then back them out.
For watch with the date
display.
30
Second clic
k
Settin
g
time
First click
Setting date
Setting date
1) Pull the crown out to the first click.
2) Set the date by turning the crown.
3) Push the crown in to the normal position.
● Avoid setting the watch or the calendar
during the time from 8:00p.m. to 11:00a.m.
(If the watch is set during this period of
time, the calendar may not change in the
following day.)
For watch with the day-date
display.
Second click
Settin
g
time
First click
Setting date or day
30
THU
Setting date or day
1) Pull the crown out to the first click.
2) Set the date or day by turning the crown.
3) Push the crown in to the normal position.
● When a day of the week has changed after
0:00a.m., the pointer moves. Once and
then, moves again to indicate the following
day.
● The watch attached with a bezel can
measure the elapsed time. Align the ▼
mark on the bezel with the minute hand
by turning it so that the time elapsed from
the ▼ mark can be measured.
Elapsed
time
Start