User manual

Operation Guide ANA(ST4)V.A
2
Setting the Time, Day
and Day of the Week
Minute hand
Day of the week
Hour hand
First click
(Setting day and
day of the week)
Second click
(Setting time)
Crown
(Normal position)
Day
Second hand
• Some water resistant models are equipped
with a screw lock crown.
• With such models, you must unscrew the
crown in the direction noted in the
illustration to loosen it before you can pull it
out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water
resistant while their crowns are loosened.
Be sure to screw the crowns back in as far
as they will go after making any setting.
● The watch attached with a bezel can
measure the elapsed time. Align the ▼
mark on the bezel with the minute hand
by turning it so that the time elapsed from
the ▼ mark can be measured.
Elapsed
time
Start
Using the Stopwatch
To set the time
1. Pull the crown out to the second click when the
second hand is at 12 o’clock position and the
second hand stops.
2. Set the hands by rotating the crown. Rotate the
crown to move the hands clockwise. Move the
minute hand four or five minutes past the time
you want to set, and then back it up to the
proper setting.
• Carefully set the time, making sure to
distinguish between AM and PM.
3. Push the crown back in to the normal position
to restart timekeeping.
To set the day
1. Pull the crown out to the first
click.
2. Set the day by rotating the
crown away from you (in the
direction indicated by the
arrow in the illustration).
3. Push the crown back in to the
normal position.
• Avoid changing the date setting
while the current time is
between 9:00 p.m. and 1:00
a.m.
To set the day of the week
1. Pull the crown out to the first
click.
2. Set the day of the week by
rotating the crown towards you
(in the direction indicated by
the arrow in the illustration).
3. Push the crown back in to the
normal position.
• Avoid changing the day of the
week setting while the current
time is between 11:00 p.m. and
2:00 a.m.
The stopwatch lets you measure elapsed time up
to 59 minutes, 59 seconds.
To measure elapsed time
1. Press A to start the stopwatch.
2. Press A to stop the stopwatch.
• You can resume the measurement operation
by pressing A again.
3. Check the elapsed time.
• Press B to reset the stopwatch.
This will enter the Timekeeping Mode.
Notes:
• Do not try to perform stopwatch operations
while the crown is pulled out either to the first or
second click. If you try to press a button, you
might accidentally cause the crown to rotate and
change the current time or day setting.
• If the starting positions of the stopwatch minute
hand and second hand become misaligned, use
the following procedures to adjust the positions
of the hands so they point to 12 o’clock when
the stopwatch is reset.
To adjust the positions of the stopwatch
hands
1. Press B to reset the stopwatch, and check the
alignment of the stopwatch minute hand and
second hand.
2. Pull out the crown to the second click.
3. Press A to move the stopwatch minute hand
and second hand.
• Holding down A will start high-speed
movement of the stopwatch minute hand and
second hand.
4. If the stopwatch minute hand is aligned
correctly, proceed to step 5. To return the
minute hand to the 12 o’clock position, press
B.
5. After making the adjustments you want, push
the crown back in to its normal position.
• Note that pulling the crown out also stops the
timekeeping second hand. After performing the
above procedure, you should also adjust the
timekeeping setting.
Stopwatch minute hand
Stopwatch second hand