User manual

Operation Guide ANA(J4)V.A
2
Setting the Time and Date
• Some water resistant models are equipped
with a screw lock crown.
• With such models, you must unscrew the
crown in the direction noted in the illustration
to loosen it before you can pull it out. Do not
pull too forcibly on such crowns.
• Also note that such watches are not water
resistant while their crowns are loosened.
Be sure to screw the crowns back in as far as
they will go after making any setting.
Crow
n
● The watch attached with a bezel can
measure the elapsed time. Align the ▼
mark on the bezel with the minute hand by
turning it so that the time elapsed from the
▼ mark can be measured.
Elapsed
time
Start
To set the date
1) Pull the crown out to the first click.
2) Set the date by turning the crown.
3) Push the crown in to the normal position.
● Avoid setting the date during the time from
8:00p.m. to 1:00a.m. (If the watch is set during
this period of time, the date may not change in
the following day.)
To set the month
While the day hand is pointing to 1, press A to
advance the month setting by one month.
● The month also advances whenever you
change the day setting from 31 to 1.
Month
Crown
(Normal position
)
First click
(Setting date)
Date
To set the time and day of the week
1) Pull the crown out to the second click when the
second hand is at 12 o’clock position and the
second hand stops.
2) Set the hands by turning the crown. As you do,
the day of the week changes accordingly.
• After setting day of the week, carefully set the time,
making sure to distinguish between AM and PM.
3) In accordance with a time signal, push the
crown in.
24-Hour Hand
The 24-hour hand indicates the current hour of the
day, making one complete rotation every 24 hours.
Day of
the week
24-hour hand
Crown (Normal position)
First click
(Setting date)
Second click
(Setting time and
day of the week)