User manual

ManualsBrandsCasio ManualsWatch3241

Operation Guide 3241

E-9

Alarms

You can set ﬁ ve independent Daily Alarms. When an alarm

is turned on, the alarm tone sounds when the alarm time

is reached. One of the alarms can be conﬁ gured as a

snooze alarm or a one-time alarm, while the other four are

one-time alarms.

You also can turn on an hourly time signal that causes the

watch to beep twice every hour on the hour.

There are ﬁ ve alarm screens numbered x

through

The hourly time signal screen is indicated by

:00

When you enter the Alarm Mode, the screen you were x

viewing when you last exited the mode appears ﬁ rst.

All of the operations in this section are performed in the x

Alarm Mode, which you enter by pressing C (page E-4).

Alarm number

Alarm time

(Hour : Minutes)

E-8

To toggle between 12-hour and 24-hour timekeeping

In the Timekeeping Mode, press D to toggle between 12-hour timekeeping and

24-hour timekeeping.

With the 12-hour format, the x P (PM) indicator appears to the left of the hour digits for

times in the range of noon to 11:59 p.m. and no indicator appears to the left of the

hour digits for times in the range of midnight to 11:59 a.m.

With the 24-hour format, times are displayed in the range of 0:00 to 23:59, without x

any indicator.

The 12-hour/24-hour timekeeping format you select in the Timekeeping Mode is x

applied in all other modes.

E-7

When the setting you want to change is ﬂ ashing, press 3. D to change it as

described below.

To change this setting Perform this button operation

Seconds

Press D to reset to 00.

Hour, Minutes, Year, Month, Day

Press D to increase the setting.

Pressing x D while the seconds are in the range of 30 to 59 resets them to 00 and

adds 1 to the minutes. In the range of 00 to 29, the minutes are unchanged.

Press 4. A to exit the setting screen.

The day of the week is automatically displayed in accordance with the date (year, x

month, and day) settings.

The year can be set in the range of 2000 to 2099. x

The watch’s built-in full automatic calendar automatically makes allowances for x

different month lengths and leap years. Once you set the date, there should be no

reason to change it except after you have the watch’s battery replaced.

E-6

Timekeeping

Use the Timekeeping Mode to set and view the current

time and date.

To set the time and date

In the Timekeeping Mode, hold down 1. A until the

seconds start to ﬂ ash, which indicates the setting

screen.

Press 2. C to move the ﬂ ashing in the sequence shown

below to select other settings.

Seconds Hour Minutes

YearMonthDay

Month – Day

PM indicator

Hour : Minutes Seconds

Day of week

E-5

In any mode, hold down x C for about one second to return to the Timekeeping

Mode.

Countdown Timer

Mode

Stopwatch Mode Dual Time Mode

E-4

General Guide

Press x C to change from mode to mode.

In any mode, press x B to illuminate the display.

Timekeeping Mode Alarm Mode

E-3

Procedure Lookup

The following is a handy reference list of all the operational procedures contained in

this manual.

To set the time and date ......................................................................................... E-6

To toggle between 12-hour and 24-hour timekeeping ......................................... E-8

To set an alarm time .............................................................................................. E-11

To test the alarm .................................................................................................... E-14

To turn Alarms

through

on and off ............................................................... E-14

To select the operation of Alarm

...................................................................... E-15

To turn the hourly time signal on and off ............................................................ E-16

To use the countdown timer ................................................................................. E-17

To set the countdown start time .......................................................................... E-18

To turn auto-repeat on and off ............................................................................. E-19

To measure times with the stopwatch ................................................................. E-21

To set the Dual Time ............................................................................................. E-22

E-2

Contents

General Guide .......................................................................................................... E-4

Timekeeping ............................................................................................................. E-6

Alarms ...................................................................................................................... E-9

Countdown Timer .................................................................................................. E-17

Stopwatch .............................................................................................................. E-20

Dual Time ............................................................................................................... E-22

Reference ............................................................................................................... E-23

Speciﬁ cations ........................................................................................................ E-25

E-1

About This Manual

Button operations are indicated using the letters shown x

in the illustration.

Each section of this manual provides you with the x

information you need to perform operations in each

mode. Further details and technical information can be

found in the “Reference” section.

MA1108-EA

Summary of content (3 pages)

PAGE 1
MA1108-EA Operation Guide 3241 About This Manual x Button operations are indicated using the letters shown in the illustration. x Each section of this manual provides you with the information you need to perform operations in each mode. Further details and technical information can be found in the “Reference” section. E-1 Procedure Lookup Contents General Guide .......................................................................................................... E-4 Timekeeping......................
PAGE 2
Operation Guide 3241 To set an alarm time Alarm Types The alarm type is determined by the settings you make, as described below. x Daily alarm Set the hour and minutes for the alarm time. This type of setting causes the alarm to sound everyday at the time you set. x Date alarm Set the month, day, hour and minutes for the alarm time. This type of setting causes the alarm to sound at the specific time, on the specific date you set. x 1-Month alarm Set the month, hour and minutes for the alarm time.
PAGE 3
Operation Guide 3241 To measure times with the stopwatch Stopwatch 1/100 second Hour Seconds Minutes The stopwatch lets you measure elapsed time, split times, and two finishes. x The display range of the stopwatch is 23 hours, 59 minutes, 59.99 seconds. x The stopwatch continues to run, restarting from zero after it reaches its limit, until you stop it. x The stopwatch measurement operation continues even if you exit the Stopwatch Mode.