User manual

1977-2
To turn the daily alarm and hourly time signal on and off
Press
BB
while in the Alarm Mode to change the status of the daily alarm and hourly
time signal in the following sequence.
• The alarm on indicator (ALM) and the Hourly Signal on indicator (SIG) are shown on
the display in all modes while these functions are turned on.
To test the alarm sound
Hold down
EE
while in the Alarm Mode to sound the alarm.
To set the alarm time
1. Hold down
AA
until the hour setting starts to flash on the display. The hour setting
flashes because it is selected.
• This operation automatically turns on the Daily Alarm.
2. Press
CC
to change the selection in the following sequence.
3. While the hour or minutes setting is selected (flashing) press
EE
to increase it or
BB
to decrease it. Holding down either button changes the current setting at high
speed.
• The format (12-hour and 24-hour) of the alarm time matches the format you select
for normal timekeeping.
• When setting the alarm time using the 12-hour format, take care to set the time
correctly as morning (no indicator) or afternoon (P).
4. After you set the alarm time, press
AA
to return to the Alarm Mode.
• If you do not operate any button for a few minutes while a setting is flashing, the
flashing stops and the watch goes back to the Alarm Mode automatically.
Hour Minutes
ALM SIG
Hourly Time
Signal Only
Both ON Both OFF Daily Alarm
Only
ALM SIG
ALARM MODE
When the Daily Alarm is turned on, the alarm sounds for 20 seconds at the preset
time each day. Press any button to stop the alarm after it starts to sound. When the
Hourly Time Signal is on, the watch beeps every hour on the hour.
Mode indicator
Alarm on indicator
Hours Minutes
Hourly time signal
on indicator